How To Remove Paint Protection Film?

This tutorial will instruct you on how to remove 3M invisible paint protection film that has become brittle over the years and does not peel off in nice easily manageable strips. With a few easily attainable tools and a lot of patience, one can make take the film off making it look like it was never there.

Protective Films

Steps

1. Test an area of the protective film with the scraper. Be sure not to use a metal scraper as it could scratch the paint finish.

You may use some auto-trim tools that are made of poly/nylon and are safe for the paint surface.

Gently stick the edge of the scraper underneath the edge of the film and push against the film to see how easy it will come off.

2. If you only get little tiny pieces at a time, then the best way is to use a heat gun, heat up a small section of the film. Do not get the heat gun too close to the car, 8–12 inches (20.3–30.5 cm) will work best. Hold the heat gun on the section for about a minute or two. If the protective film comes off fairly easily and in large strips, a heat gun may not be necessary but would help.

3. Using the scraper again, gently push underneath the protective film of the heated area and the film should now come up in bigger strips. It is okay and normal to not get everything off in each pass.

As long as you get the top layer of the film off the rest will come off easily with Goo Gone adhesive remover.

More Protective Film Solutions

4. Work in small sections at a time repeating the process of heating then scraping. You will know when you need to heat again as the strips being removed will get smaller. This process will take some time so remember to be patient!

Protective Film for Deep Drawing

5. Have adhesive left behind. Grab a small microfiber towel and spray some Goo Gone onto it.

Gently rub over the area on the car where the adhesive is.

Work in small sections and spray more Goo Gone on the towel as needed. Rub over the areas until the adhesive has been removed. The plastic scraper can also help with this step.

6. Optional step: If you wish to be very certain you have removed all the adhesive, or get tired of trying to get every little piece, a clay bar kit is an answer. Spray down a small area, 2x2, and then rub the clay bar over it.

The clay bar will pull up the rest of the particles that are left and make a nice smooth finish.

7. When all the adhesive has been removed, wipe the entire area down with another dry microfiber towel.

8. Using your car wax of choice, wax the entire area of the car where the invisible shield was. So that it doesn't stand out, you may wish to wax the entire hood or just go for the whole car!

The protection films NB Protective Film provides will definitely not leave any glue stains on the surface of products applied, you can easily peel it off whenever you want. If you're interested in the best protective film we provide, welcome to contact us today or request a quote, we won't disappoint you for sure.